SAE J2777 Recommended Best Practice for Climatic Wind Tunnel Correlation

时间:2024-05-16 06:28:18 来源: 标准资料网 作者:标准资料网 阅读:8450
下载地址: 点击此处下载
Product Code:SAE J2777
Title:Recommended Best Practice for Climatic Wind Tunnel Correlation
Issuing Committee:Interior Climate Control Committee
Scope:With many corporations and suppliers conducting development and validation tests at different Climatic Wind Tunnel sites, there is an increasing need for a recommended best practice that defines a process by which climatic wind tunnels can be correlated. This document addresses the test methods and metrics used to obtain similar results, independent of location, for Heating Ventilation and Air Conditioning (HVAC) and Powertrain Cooling (PTC) development. This document should be used as a guideline to make sure key aspects of tunnel testing are covered when comparing various climatic wind tunnel facilities.The depth of the correlation program is ultimately influenced by program objectives. Therefore a correlation program, for the intent and purposes of this document, can range from just a few tests to a full analysis that involves multiple vehicle tests identifying limitations and statistical boundaries. Using to recommendations in this document will eliminate most of the items that effect facility mismatch in a correlation program
基本信息
标准名称:空气质量 总悬浮微粒的测定 重量法
英文名称:Air quality-Determination of total suspended particulates-Gravimetric method
中标分类: 环境保护 >> 环境保护采样、分析测试方法 >> 大气环境有毒物质分析方法
ICS分类: 环保、保健与安全 >>
发布部门:国家环境保护局
发布日期:1988-08-16
实施日期:1988-12-01
首发日期:1988-08-16
作废日期:2006-07-28
主管部门:国家环境保护总局
归口单位: 国家环境保护总局
起草单位:北京环保监测中心
出版日期:1900-01-01
页数:3页
适用范围

本标准为贯彻执行GB 3095-82《大气环境质量标准》而制定。本标准适合于空气中总悬浮微粒的测定。总悬浮微粒指空气动力学直径小于100μm的微粒。

前言

没有内容

目录

没有内容

引用标准

没有内容

所属分类: 环境保护 环境保护采样 分析测试方法 大气环境有毒物质分析方法 环保 保健与安全
Product Code:SAE AMS5876
Title:Cobalt Alloy, Corrosion and Heat Resistant, Strip, 20cr 15ni 40co 7.0mo 16fe, Solution Heat Treated and Cold Rolled, Vacuum Induction Plus Vacuum Consumable Electrode Melted
Issuing Committee:Ams F Corrosion Heat Resistant Alloys Committee
Scope:This specification covers a high-strength, corrosion and heat resistant cobalt alloy in the form of strip 0.100 inch (2.54 mm) and under in specified thickness and 4.000 inches (101.60 mm) and under in specified width. This strip has been used typically for springs requiring a combination of high strength up to 800 degrees F (427 degrees C) after aging, excellent corrosion resistance, and good fatigue properties, but usage is not limited to such applications. Alloy is nonmagnetic.